Weather was great today and I got a little bit of time to cut the useless brackets and recheck all the clearances now that I got a finished bracket and measured where snout should be.. intercooler... charge pipes..




ignore the red pipes..lol



Look at all that new acquired room I will be able to blump the intake side of the SC with 4" to 3"



you can see how close the bracket comes...building the bracket was not an easy task since I had to measure intensely and still I have to figure out how to fit the bypass valve ..very important piece of the charger setup...




My Miller 3" MAF pipe that will be used for this project..



now thats close...




more to come..am getting really close in starting the engine with the charger installed :)